VIIRS/NPP Land Surface Temperature and Emissivity 6-Min L2 Swath 750m
Product Identifier: VNP21
Description:
The VIIRS/NPP Land Surface Temperature and Emissivity 6-Min L2 Swath 750m product (VNP21) uses a physics-based Temperature Emissivity Separation (TES) algorithm to dynamically retrieve both the LST and Emissivity simultaneously for the three VIIRS thermal infrared bands (M14, M15 and M16) at a spatial resolution of 750 m per pixel. The VNP21 algorithm is based on the ASTER Temperature Emissivity Separation (TES) algorithm, which uses full radiative transfer simulations for the atmospheric correction, and an emissivity model based on the variability in the surface radiance data to dynamically retrieve both LST and spectral emissivity. The TES algorithm is combined with an improved Water Vapor Scaling (WVS) atmospheric correction scheme to stabilize the retrieval during very warm and humid conditions. Simulations and validation results available in the ATBD have shown consistent accuracies at the 1 K level over all land surface types including vegetation, water, and deserts.
Point of Contact:
Glynn C. Hulley (PI)
glynn.hulley@jpl.nasa.gov
Principal Investigator(s):
Glynn C. Hulley (PI)
MS 183-509
Jet Propulsion Laboratory
4800 Oak Grove Dr.
Pasadena, CA 91109
Email: glynn.hulley@jpl.nasa.gov
Office: (818) 354-2979
============================================================================
General Construct
dimensions:
YDim:number_of_lines = 3248 ;
XDim:number_of_pixels = 3200 ;
variables:
float32 Latitude(YDim:number_of_lines, XDim:number_of_pixels) ;
Latitude:long_name = "Latitude data" ;
Latitude:scale_factor = 1.0 ;
Latitude:add_offset = 0.0 ;
Latitude:units = "degrees north" ;
Latitude:_FillValue = -999.0 ;
Latitude:valid_range = -90.0, 90.0 ;
float32 Longitude(YDim:number_of_lines, XDim:number_of_pixels) ;
Longitude:long_name = "Longitude data" ;
Longitude:scale_factor = 1.0 ;
Longitude:add_offset = 0.0 ;
Longitude:units = "degrees east" ;
Longitude:_FillValue = -999.0 ;
Longitude:valid_range = -180.0, 180.0 ;
uint8 Emis_14(YDim:number_of_lines, XDim:number_of_pixels) ;
Emis_14:long_name = "Band 14 Emissivity" ;
Emis_14:scale_factor = 0.002 ;
Emis_14:add_offset = 0.49 ;
Emis_14:units = "n/a" ;
Emis_14:_FillValue = 0 ;
Emis_14:valid_range = 1, 255 ;
uint16 Emis_14_err(YDim:number_of_lines, XDim:number_of_pixels) ;
Emis_14_err:long_name = "Band 14 Emissivity error" ;
Emis_14_err:scale_factor = 0.0001 ;
Emis_14_err:add_offset = 0.0 ;
Emis_14_err:units = "n/a" ;
Emis_14_err:_FillValue = 0 ;
Emis_14_err:valid_range = 1, 65535 ;
uint8 Emis_15(YDim:number_of_lines, XDim:number_of_pixels) ;
Emis_15:long_name = "Band 15 Emissivity" ;
Emis_15:scale_factor = 0.002 ;
Emis_15:add_offset = 0.49 ;
Emis_15:units = "n/a" ;
Emis_15:_FillValue = 0 ;
Emis_15:valid_range = 1, 255 ;
uint16 Emis_15_err(YDim:number_of_lines, XDim:number_of_pixels) ;
Emis_15_err:long_name = "Band 15 Emissivity error" ;
Emis_15_err:scale_factor = 0.0001 ;
Emis_15_err:add_offset = 0.0 ;
Emis_15_err:units = "n/a" ;
Emis_15_err:_FillValue = 0 ;
Emis_15_err:valid_range = 1, 65535 ;
uint8 Emis_16(YDim:number_of_lines, XDim:number_of_pixels) ;
Emis_16:long_name = "Band 16 Emissivity" ;
Emis_16:scale_factor = 0.002 ;
Emis_16:add_offset = 0.49 ;
Emis_16:units = "n/a" ;
Emis_16:_FillValue = 0 ;
Emis_16:valid_range = 1, 255 ;
uint16 Emis_16_err(YDim:number_of_lines, XDim:number_of_pixels) ;
Emis_16_err:long_name = "Band 16 Emissivity error" ;
Emis_16_err:scale_factor = 0.0001 ;
Emis_16_err:add_offset = 0.0 ;
Emis_16_err:units = "n/a" ;
Emis_16_err:_FillValue = 0 ;
Emis_16_err:valid_range = 1, 65535 ;
uint8 Emis_ASTER(YDim:number_of_lines, XDim:number_of_pixels) ;
Emis_16:long_name = "ASTER GED Grid Mapped Emissivity ;
Emis_16:scale_factor = 0.002 ;
Emis_16:add_offset = 0.49 ;
Emis_16:units = "n/a" ;
Emis_16:_FillValue = 0 ;
Emis_16:valid_range = 1, 255 ;
uint16 LST(YDim:number_of_lines, XDim:number_of_pixels) ;
LST:long_name = "Land Surface Temperature" ;
LST:scale_factor = 0.02 ;
LST:add_offset = 0.0 ;
LST:units = "K" ;
LST:_FillValue = 0 ;
LST:valid_range = 7500, 65535 ;
uint8 LST_err(YDim:number_of_lines, XDim:number_of_pixels) ;
LST_err:long_name = "Land Surface Temperature error" ;
LST_err:scale_factor = 0.04 ;
LST_err:add_offset = 0.0 ;
LST_err:units = "K" ;
LST_err:_FillValue = 0 ;
LST_err:valid_range = 1, 255 ;
int16 PWV(YDim:number_of_lines, XDim:number_of_pixels) ;
PWV:long_name = "Precipitable Water Vapor" ;
PWV:scale_factor = 0.001 ;
PWV:add_offset = 0.0 ;
PWV:units = "cm" ;
PWV:_FillValue = n/a ;
PWV:valid_range = 0,65535 ;
uint16 QC(YDim:number_of_lines, XDim:number_of_pixels) ;
QC:long_name = "Quality control for LST and emissivity" ;
QC:scale_factor = n/a ;
QC:add_offset = n/a ;
QC:units = "none" ;
QC:_FillValue = n/a ;
QC:valid_range = 0, 65535 ;
QC:data description = "Quality Assurance (QA)",
"0-1 Mandatory QA flags\n",
" 00 --- Pixel produced, good quality, no further QA info necessary\n",
" 01 --- Pixel produced but unreliable quality. Either one or more of the following conditions are met: emissivity in both bands 15 and 16 < 0.95, retrieval affected by nearby cloud, low transmissivity due to high water vapor loading (<0.4), sensor view angles > 55 degrees. Recommend more detailed analysis of other QC information\n",
" 10 --- Pixel not produced due to cloud\n",
" 11 --- Pixel not produced due to reasons other than cloud (e.g. ocean pixel, poorly calibrated input radiance, TES algorithm divergence flag) \n",
"2-3 Data quality flag\n",
" 00 --- Good data quality of L1B bands 14, 15, 16\n",
" 01 --- Missing pixel\n",
" 10 --- Fairly calibrated\n",
" 11 --- Poorly calibrated, TES processing skipped\n",
"4-5 Cloud flag\n",
" 00 --- Cloud free pixel\n",
" 01 --- Thin cirrus\n",
" 10 --- Pixel within 2 pixels of nearest cloud (~1.5km)\n",
" 11 --- Cloud pixel\n",
"6-7 TES Iterations (k)\n",
" 00 --- = >= 7 (Slow convergence)\n",
" 01 --- = 6 (Nominal)\n",
" 10 --- = 5 (Nominal)\n",
" 11 --- = <5 (Fast)\n",
"8-9 Atmospheric Opacity\n",
" 00 --- = >= 0.3 (Warm, humid air; or cold land)\n",
" 01 --- = 0.2 - 0.3 (Nominal value)\n",
" 10 --- = 0.1 - 0.2 (Nominal value)\n",
" 11 --- = <0.1 (Dry, or high altitude pixel)\n",
"10-11 Min-Max Difference (MMD). Difference between minimum and maximum emissivity for bands 14, 15, 16\n",
" 00 --- = >0.15 (Most silicate rocks)\n",
" 01 --- = 0.1 - 0.15 (Rocks, sand, some soils)\n",
" 10 --- = 0.03 - 0.1 (Mostly soils, mixed pixel)\n",
" 11 --- = <0.03 (Vegetation, snow, water, ice)\n",
"12-13 Emissivity accuracy\n",
" 00 --- = >0.017 (Poor performance)\n",
" 01 --- = 0.015 - 0.017 (Marginal performance)\n",
" 10 --- = 0.013 - 0.015 (Good performance)\n",
" 11 --- = <0.013 (Excellent performance)\n",
"14-15 LST accuracy\n",
" 00 --- = >2.5 K (Poor performance)\n",
" 01 --- = 1.5 - 2.5 K (Marginal performance)\n",
" 10 --- = 1 - 1.5 K (Good performance)\n",
" 11 --- = <1 K (Excellent performance)\n",
"" ;
uint8 View_angle(YDim:number_of_lines, XDim:number_of_pixels) ;
View_angle:long_name = "Sensor Zenith" ;
View_angle:scale_factor = 0.5 ;
View_angle:add_offset = 0.0 ;
View_angle:units = "degrees" ;
View_angle:_FillValue = 255 ;
View_angle:valid_range = 0, 180 ;
uint8 oceanpix(YDim:number_of_lines, XDim:number_of_pixels) ;
oceanpix:long_name = "land ocean inland_water" ;
oceanpix:scale_factor = 1.0 ;
oceanpix:add_offset = 0.0 ;
oceanpix:units = "n/a" ;
oceanpix:_FillValue = n/a ;
oceanpix:valid_range = 0, 2 ;
Tokens for Downloading LAADS DAAC Data
A LAADS DAAC download token will help make file downloads faster, but is only usable for LAADS DAAC web sites. A LAADS DAAC token
will not work with other Earthdata sites.
Generating LAADS DAAC token …
Please copy and save the token below for use with any supported LAADS download utilities or scripts.
To test, run the following wget download command in your terminal and see if it successfully downloaded the README text file located at the root of the LAADS archive. See also LAADS documentation on how to use wget
We are currently unable to generate a LAADS DAAC token. Please try again later or contact MODAPS Support with any questions.
An Earthdata Download token (EDL) will work on any Earthdata site including all LAADS DAAC sites, but download performance from the LAADS DAAC can be much slower due to the extra network connections needed to check credentials at Earthdata.
Confirm Download of Multiple Files
Verifying login status…
Please confirm before starting this batch download of listed below totaling , one file at a time.
Once a batch download begins, your browser may not provide a way to cancel the batch aside from closing the browser entirely or stopping individual downloads one at a time. If in doubt, try selecting a smaller number of files for download. MODAPS Support is available to help with any questions.
Browser configurations
Some users might have to approve once (e.g., click "Allow") to allow for future downloads of multiple files.
To avoid a new download prompt for each file, ensure the following settings are configured in your browser:
Chrome: Settings > Advanced > Ask where to save each file before downloading > Off
Firefox:
Preferences > Files and Applications > Save files to…
Click checkbox “Do this automatically for files like this from now on”